News & Events

Manufacturing workshop stainless steel flagpole

Workshop for processing and stamping stainless steel tinta flagpoles. Processing and stamping of stainless steel tinta

Workshop for processing and stamping stainless steel tinta flagpoles. Stamping and stamping of stainless steel tinta flagpoles, the taper flagpole pattern is gradually smaller from the bottom to the top, and the flagpole size and thickness depend on the area and wind area and depending on the flagpole height. Stainless steel flagpoles are currently a commonly used product in tinta stainless steel flagpoles, the cause of which cannot be separated from the stamping function of stainless steel.

The material properties are respectively puff forming performance, flanging forming efficiency, reaming forming efficiency and bending forming performance, respectively. To understand stamping performance, we must first understand the stamping process. The basic stamping forming process includes: drawing process, swelling process, flanging process (including reaming) and bending process.

The process of forming bulge, processing and bending the 304 stainless steel plate into a uniform taper stainless steel flagpole

Puffing is a stamping method that uses a die to thin the thickness of the workpiece and increase the surface area to obtain the geometric shape of the part.

The characteristic is that the blank is crushed to death by the drum and cannot flow into the mold, completely depending on the elongation of the material itself.

Deep drawing process

Deep drawing is a stamping process that uses a special die to produce a flat blank obtained after punching or cutting into an open hollow.

Its characteristic is that the sheet material can flow into the concave die under the drive of the convex die, that is, it depends on the fluidity and elongation of the material to form.

Bending process

Roll forming is a forming method in which plates, rods, tubes or profiles are bent into certain shapes and angles.

Ø Ordinary 304 thin plate will not cause bending or cracking.

Steel grade Ø 430 is prone to bending and cracking when the plate thickness is thick.

Forming process of ciphertext and stamping method

Flange stamping is a stamping method that uses a die to turn the hole edge or the outer edge of the workpiece into a vertical edge. Workshop for processing and stamping stainless steel tinta flagpoles. Stamping and stamping of stainless steel tinta flagpoles, tapered flagpoles from the bottom to the top are gradually smaller.

Previous: Tinta stainless steel electric flagpole motor .
Next: The strength and flexibility of tinta stainless steel flagpole enhances wind resistance.